Magma 7 Slot Series Especificações descarregar pdf (Página 60)

$33(1',;'3&,EDVHG6XQ

:RUNVWDWLRQ*XLGH 

Introduction

MAGMA's PCI Expansion System provides a cost-effective way to add

PCI cards to PCI-based Sun workstations. The PCI expansion system

is compliant with the PCI 2.1 specification. Four, seven and thirteen slot

configurations are available. Each slot in the expansion system is a 32-

bit wide PCI slot (7 slot 64-bit systems are also available) with master

capability to provide data throughput up to 132 MB per second. The

PCI expansion system will work transparently in a Sun workstation and

does not require any additional software.

Requirements

SPARC System: OpenBoot firmware 3.11 or higher.

x86 System: System BIOS must support at least 3 PCI Bus levels.

Operating System

Solaris 2.5 or higher.

Host Computer: One available PCI slot.

Installation

1. Power down the computer. Install the PCI

Host

Interface Card in

an available PCI slot in the Sun (host) computer.

2. Install your PCI card(s) in the PCI Expansion System. The first PCI

slot (device number 4) is the bottom slot.

3. Attach one end of the PCI expansion cable to the PCI Host

Interface Card and the other end to the 4 Slot PCI Expansion

System. Secure it with the captive thumbscrews.

4. Always power on the PCI Expansion System first, and then power

up the host computer.

Sample Configuration

In this sample setup, we use a Sun Ultra 5 workstation and a MAGMA 7

Slot PCI Expansion System. We installed an Adaptec SCSI card in the

first PCI slot and an Ethernet card in the second PCI slot of the

expansion chassis. To check if the Ultra 5 sees the PCI Expansion

System and the PCI cards, we can use the OpenBoot command

show-

devs

ok show-devs

/SUNW,UltraSPARC-IIi@0,0

/pci@1f,0

/virtual-memory

/memory@0,10000000

1 2 ... 55 56 57 58 59 60 61 62 63

Sem comentários

Magma 7 Slot Series Especificações Página 60