Magma 7 Slot Series Especificações descarregar pdf (Página 19)

Step One: Remove PCI Expansion System Cover

WARNING

High voltages are present inside the chassis when the unit’s powe

cord is plugged into an electrical outlet. Disconnect the power cord

from its source before removing the chassis cover. Turning the system

power off at the power on/off switch does not remove power to

components. High voltage is still present.

CAUTION

Before touching anything inside the chassis, move to an ESD station

and follow proper ESD procedure. Failure to do so may result in

electrostatic discharge damaging the computer or its components. Fo

more information, see “Protecting Against Electrostatic Discharge”.

Seven screws retain the cover on the 4 Slot chassis. They are located

on the rear of the unit, one on the left, right and top center of the cover's

back edge and two on each side of the unit that are used when

attaching the rack-mount ears. Remove these screws to open the

chassis. Disengage the cover from the guides at the front of the chassis

by firmly grasping the sides of the cover and pulling upward to lift the

cover off the chassis.

CAUTION

When replacing the cover, be sure that the front edge guides on the

enclosure cover engage the inner lip of the expansion chassis.

Step Two: Install PCI Cards in PCI Expansion System

WARNING

High voltages are present inside the chassis when the unit’s powe

cord is plugged into an electrical outlet. Disconnect the power cord

from its source before removing the chassis cover. Turning the system

power off at the power on/off switch does not remove power to

components. High voltage is still present.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 62 63

Sem comentários

Magma 7 Slot Series Especificações Página 19