Magma EOwave Manual do Utilizador descarregar pdf (Página 4)

! ! !

_____________________________________________________________________________________________________!

___________________________________________________________________________

I - Connections

Connections are located on the rear side of the control panel.

DC IN: The MAGMA uses an external DC - 15 V ‒ 0,8 A power supply. Use the

power supply provided with the unit. Never open the unit when it is switched on.

IN: main audio in to process external signals.

OUT: main audio out. Plug it to your amplifier audio in. Can also be used as a

headphone out

USB: For MIDI over USB and firmware update.

MIDI IN: to control the MAGMA

Connect the audio out of the MAGMA to the audio in of our mixing desk.

Connect the power supply to the power. There is no on/off switch. When switched on,

some of the LEDs will light up.

If you want to synchronize the MAGMA to an external MIDI device, connect the out of

the MIDI device to the MIDI in of the MAGMA.

If you want to play the MAGMA from a keyboard, connect the MIDI out from the

keyboard to the MIDI in of the MAGMA.

___________________________________________________________________________

II - Start

On power up, the MAGMA is always in note mode. Press play to start a sequence.

Adjust the speed with the TEMPO VAL dial.

The MAGMA has a total of 256 presets divided in 4 banks. Only the first bank is filled

with factory presets.

A preset is represented by a BANK (1-4) SUB-BANK (1-8) number (1-8)

To change the presets, press SHIFT + PRESET to enter the preset mode. Select a

preset with the TEMPO VAL dial or click on the lower row to select the sub-bank and

the upper row for the number.

Preset 1 of the first bank will be called preset 1-1 (lower row 1 ‒ upper row 1)

Preset 27 will be lower row 2 ‒ upper row 7

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Magma EOwave Manual do Utilizador Página 4