Magma ROBEN-3TM Manual do Utilizador descarregar pdf (Página 22)

Magma

Roben 3 | Chapter 2 Hardware Installation

LEDs D6 and D8 are illuminated when power cord is attached to expansion unit. This means the expansion unit is

on standby-mode. The magma device is” switched off” on the electronic interface (but it draws some power). On

standby mode the Magma is not performing its primary function; it is waiting to be activated by a remote power or

remote controller. See picture below.

FIGURE T2-C

If the above LEDs are not coming ON, please check the power standby cable make sure it is firmly connected to

Thunderbolt Interface card power connector (J7). See page 25.

Thunderbolt™ 2 Interface Card LEDs: Standby-Mode

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 93 94

Sem comentários

Magma ROBEN-3TM Manual do Utilizador Página 22